NC State
Attiogbe, F. K., Bose, S. K., Wang, W., McNeillie, A., and Francis, R. C. (2010). "The peroxymonocarbonate anions as pulp bleaching agents. Part 1. Results with lignin model compounds and chemical pulps," BioRes. 5(4), 2208-2220.


The peroxymonocarbonate mono-anion (HCO4─) is generated when the bicarbonate anion is added to a H2O2 solution. The mono-anion is believed to have a pKa value of ca. 10 and as such would start dissociating to the di-anion (CO42─) at pH ca. 8. The mono-anion should demonstrate electrophilic properties, while the di-anion should be a nucleophile. In an alkaline, non-sulfur pulping process such as soda/AQ, Na2CO3 could be obtained from the chemical recovery system and carbonated with CO2 from a flue gas stream to produce NaHCO3. In such a case only H2O2 would need to be purchased to generate the peroxymonocarbonate (PMC) anions. Bicarbonate anions could also be produced from the carbonation of solutions containing NaOH, Mg(OH)2 or mined Na2CO3. One or both of the PMC anions was found to be effective in oxidizing two lignin model compounds as well as lowering the lignin content of kraft and soda/AQ hardwood pulps. The PMC anions were generated in-situ by NaHCO3 or Na2CO3 + CO2 addition to dilute H2O2 solutions.
Download PDF